Learn how to install and activate OTC PLUS 3 in 1 software on your computer. Follow step-by-step instructions for BIOS settings (MBR mode, SATA configuration) and TeamViewer activation. Compatible with 8th-gen or lower processors.
OTC PLUS 3 in 1 is a powerful diagnostic and programming tool designed for automotive professionals. It supports key programming, ECU coding, and vehicle diagnostics for a wide range of car models. To ensure smooth functionality, proper installation and BIOS configuration are essential.
OTC Plus 3 in 1 = Toyota TIS + VOLVO VIDA DICE + Nissan Consult 3 Plus
OTC Scanner GTS TIS3 With Software Prepared installed on a hard disk.
Key Features of OTC PLUS 3 in 1 Toyota /Nissan/Volvo Diagnostic tool :
Advanced vehicle diagnostics
ECU programming & coding
Key programming support
Wide vehicle coverage
OTC PLUS 3 in 1 Scanner can only support the J2534 protocol. Password is : J2534
System Requirements for OTC PLUS 3 in 1
Before installation, ensure your system meets the following requirements:
Processor: 8th generation or lower (Intel/AMD)
Hard Disk: Installed with OTC PLUS 3 in 1 software
Boot Mode: MBR (Legacy) – UEFI not supported
Hard Disk Mode: SATA (Do not use IDE mode)
OTC PLUS 3 in 1 Software Step-by-Step Installation Guide
Step 1: Install the OTC Scanner Hard Disk
Shut down your computer and install the pre-loaded OTC PLUS 3 in 1 hard disk.
Power on the system and enter BIOS setup (usually by pressing F2, DEL, or ESC during boot).
Step 2: Configure BIOS Settings
Set Boot Mode to MBR (Legacy):
Navigate to Boot Options in BIOS.
Change boot mode from UEFI to Legacy (MBR).
Save changes and exit.
Set Hard Disk Mode to SATA (Not IDE):
Go to Storage Configuration or SATA Mode.
Select AHCI or SATA Mode (Do NOT use IDE mode).
Save and exit BIOS.
Step 3: Boot into Windows & Install Software
Restart your computer and boot from the installed hard disk.
Log in to Windows and ensure all necessary drivers are installed.
Activation Process via TeamViewer
After successful installation:
Open TeamViewer on your computer.
Note down the TeamViewer ID and Password.
Send the ID and Password to the support team for activation.
The technician will remotely activate your OTC PLUS 3 in 1 software.
Troubleshooting Common Issues
Boot Failure? Ensure BIOS is set to MBR (Legacy) mode.
Software Not Working? Verify hard disk mode is SATA (not IDE).
Activation Issues? Ensure stable internet for TeamViewer connection.
The OTC PLUS 3 in 1 software is an essential tool for automotive diagnostics and programming. By following the correct BIOS settings (MBR boot mode, SATA configuration) and completing the TeamViewer activation process, you can unlock its full potential.
For further assistance, contact support with your TeamViewer details after installation.
